So after more research and a change of design and colour plan I began making the tiara.
Step 1: measure out a piece of silver wire – I measured out 100cm but I would recommend for this design now about 150cm of wire
Step 2: Place beads in a nice order on a bead tray to make sure the colour combination looks good and to get an idea of the layout.
Step 3: Fold over one end of the wire and thread the beads onto it (the folded end stops the beads from falling off)
Step 4: Start in the middle of the tiara band and wrap the wire round tightly to one end and repeat with the other side.
Step 5: Using flat nose pliers make sure the folded end is tight and then you are done!
The finished article:

I’ve got to say that I did find making it really difficult. Starting from the centre was exceptionally hard so could suggest if you have an even design starting from one end and working across.
Lilly x
Home
boutique


